Trade calibration at a glance
For body shops, glass shops and fleets with a calibration they can't run in their own bay. Every job starts on the quote form.
-
Price
Per system, from $240, at the rates on this page.
-
Coverage
Nationwide. Your quote names the service center or mobile technician that covers your ZIP code.
-
Booking
You decide once the written quote is in.
Who sends us calibrations
Body shops, glass shops, repair shops and fleets use the same form. Add your business name, and the quote comes to your shop.
-
Collision repair shops
Your bay can't run the calibration on the estimate? We calibrate each sensor the repair touched.
-
Independent glass shops
New glass in, but your shop doesn't calibrate that car? We re-aim the camera and report the result.
-
Repair and alignment shops
An alignment calls for calibration on some makes, Nissan among them. Add the alignment printout, so the quote covers the right systems.
-
Fleet vehicles
Vans, pickups and cars, each VIN quoted per system. Tell us the job it just had: glass, a front-end repair or an alignment.
What to send with the car
Add these when you ask for a quote. Your quote then lists only the sensors your repair touched.
- The work order: every part you removed, repaired or replaced near a sensor.
- Glass: genuine or aftermarket, and who supplied it.
- A replaced sensor: new or used, and whether it's set up for the car yet.
- The alignment printout: if you aligned the wheels during the repair.
Anything there that can stop a calibration, like glass the automaker hasn't approved for that camera? We raise it before scheduling.
Calibrate in your own bay, or send it to us
Plenty of shops do both, sending the space-hungry jobs out. Get a price for the car in your bay.
Send it to us
- Per system, from $240, every rate on this page
- Targets and mats for the job, supplied by us
- A service center bay, or a mobile visit where the procedure allows
- Surround view and road-drive jobs quoted like any other
- A report for each system, ready for your repair file
- One written quote per car, each system on its own line
Run it in your own bay
- Calibration equipment, plus the automaker's repair procedures by subscription
- Targets and mats for each make you calibrate
- A level floor in your shop, kept clear for each target-based (static) job
- Surround view needs a large floor and make-specific mats
- Your technician records every setup and result
- Your own estimate lines for labor and equipment time
How a sublet calibration runs
- 1
Send the VIN and work order
Use the quote form and tick the shop box. List the parts removed or replaced near a sensor, and the glass type.
- 2
Get the quote in writing
Each system and any scan get their own line. The service center or mobile technician that covers your ZIP code sends it.
- 3
Your shop or our bay
Road-drive work can be a mobile visit. Static work needs a level floor with room for targets, so your quote says: your shop or a service center bay.
- 4
Calibration and the report
Each sensor is re-aimed to the automaker's documented procedure. You get a report for each system to keep with the repair order.
Trade calibration prices
Put each calibration on your estimate as its own line, at these rates. Ask for the written quote.
Calibration, per system
Coding a replaced part to your vehicle
Diagnostic scan
- Same price on a mobile visit, except rows marked Shop bay only.
- Prices are before sales tax. Whether labor is taxed depends on your state; any tax that applies is itemized on your written quote.
- Dynamic calibration runs on the road, so it can be done as a mobile visit. Static calibration needs a level, lit, measured space, so whether your job can be done mobile depends on what your car's documented procedure calls for.
- Rows marked Shop bay only are done in a shop bay. The bay-and-road camera price applies when your car needs both calibrations.
Know your calibration sublet
A sublet calibration answers to the automaker's scan statement and procedure and, in some states, to glass-shop law. These tabs cover both, plus fleets.
Many collision shops run their own pre and post scans but send calibrations out.
A scan needs a scan tool. Each kind of calibration needs more:
- Static calibration: targets set around the car, on a level floor with room to place them.
- Dynamic calibration: a road drive while the camera or radar sets its aim.
- Surround view: a large floor and make-specific mats or targets.
- Coding: a new camera or radar gets the software for that car, then it's calibrated.
We calibrate each car to its automaker's (OEM) documented procedure.
Many automakers also publish a pre and post scan position statement. Each sets when the car is scanned.
| Make | Scans it calls for |
|---|---|
| Honda, Acura (July 2025) | Pre-repair scan at the estimate, post-repair scan |
| GM brands (March 2026) | Pre-repair and post-repair scan |
| Ford, Lincoln (October 2025) | Pre-repair and post-repair scan |
| Toyota, Lexus | Health check scan before and after every repair after collision damage |
| Kia | Pre-repair and post-repair scan |
| INFINITI (July 2019) | Post-repair scan required, 2008 and newer; pre-repair scan recommended |
Ford, May 2026: calibration "must be performed on any affected component." It holds with or without a fault code.
Sources: Ford ADAS statement, May 2026; Honda scan statement, July 2025; GM scan statement, March 2026.
In these states, the law puts duties on the glass shop.
- Arizona: you say whether recalibration is required. If it fails, you tell the customer and insurer where to go.
- Florida: you give written or electronic notice of whether it's required.
- Kentucky: on an insurance glass claim, you say whether it's required and if you can do it. If not, you refer them on.
- Maryland: if you also calibrate, you say whether it's required and confirm in writing the work meets the automaker's specification.
- New York: before the contract, you say whether you can calibrate. If not, you refer the customer on.
- Virginia: before the job, you say whether it's needed and whether you'll calibrate. If not, you refer the customer on.
Sources: A.R.S. 20-463.02; Fla. Stat. 559.920; KRS 367.361; Md. Code, Com. Law 14-1327; N.Y. Gen. Bus. Law 392-k; Va. Code 59.1-207.6:3.
Three duties follow the calibration. Our report gives you the result to pass on.
- The result in writing: Kentucky and Virginia want written notice of whether the calibration worked.
- No charge for a failure: Arizona, Maryland and New York bar charging for a calibration that wasn't done to spec or didn't succeed.
- Sublets in Florida: subcontracting repair work needs the customer's knowledge or consent, so tell them about ours.
Sources: KRS 367.361; Va. Code 59.1-207.6:3; A.R.S. 20-463.02; N.Y. Gen. Bus. Law 392-k; Fla. Stat. 559.920.
Fleet vehicles need calibration after the same jobs as any car. A few fleet habits add more.
- Front-end repairs: a bumper, grille or bracket job can move the radar.
- Alignment: on a Nissan, even an alignment calls for calibration.
- Accessories: a bull bar, light bar, winch or snowplow near a sensor can keep it from working as designed.
- Lift kits and wheels: a lift kit, or wheels and tires of a different size, change ride height.
List any of these in your quote request, and keep each report with that vehicle's service record.
Sources: Ford ADAS statement, May 2026; Nissan ADAS components statement, January 2026.
Questions from shops and fleets
Yes, where that car's procedure allows a mobile visit. Dynamic calibration runs on the road, so it can be done as a mobile visit.
Static calibration needs a level, lit, measured space, so whether your job can be done mobile depends on what your car's documented procedure calls for.
Surround view cameras are quoted for a service center bay. So are cars that need both a bay calibration and a road drive.
Your quote lists each system and names who calibrates the car. The report then shows each system's result, for your repair file.
Booked a scan before or after the repair too? Its results come with the report.
How liability splits on a sublet is for your own counsel or insurer to confirm.
Line by line, as quoted. Front camera calibration is $300 and front radar calibration is $330 at a service center.
Prices are per system, before sales tax where your state charges it on labor, and the full rate card is on the pricing page.
A diagnostic scan, when your job needs one, is priced and itemized separately. It goes on its own estimate line too.
Then the car isn't ready, and we tell you why. It can be a bent bracket, a used sensor, alignment out of spec, or glass the automaker hasn't approved for that camera.
Fix those, and calibration runs again.
That's between your shop and the carrier, so check first. List each calibration as its own estimate line, with the repair step behind it.
A calibration found mid-repair goes on a supplement for approval. Our written quote gives you the line to add.
Yes. Cars, vans and pickups each get their own quote, priced per system.
Tell us first about a lift kit, bull bar, light bar or plow. We check those before we quote.
A car waiting on a calibration your bay can't run? Send the VIN
Add the work order. Your quote is confirmed in writing before anything is scheduled.
Updated