Enter your ZIP to see ADAS calibration prices for your area

Jeep Forward Collision Warning Light. ADAS Calibration From $300 Per System.

Is your Jeep's forward collision light staying on, its "OFF" lamp lit, or the dash reading "FCW Unavailable Service Required"? We rule out the settings first, then re-aim the camera or radar if a repair moved it, nationwide. Send the VIN and the message below.

  • Your quote is confirmed in writing before anything is scheduled.
  • Calibration runs to full manufacturer specification.
  • A calibration certificate after the job.
STEP 1 / 3 About a minute

Tell us about your vehicle

By sending this you accept our terms.

Warning

Can I keep driving with the light on?

Yes, Jeep's owner's manuals say so. Automatic braking may be limited, so leave more room.

  • "Unavailable Service Required" means a fault on most Jeeps. Get it checked. On a Wrangler, restart first.
  • "Limited Functionality" or "AEB Limited Service Required" is a passing limit, like a dirty windshield.
  • Off-road? The manuals say to switch collision warning off. Turn it back on after.

Sources: Jeep, 2022 Wrangler Owner's Manual; Jeep, 2022 Grand Cherokee Owner's Manual.

Which Jeep light is on, and what it means

Your Jeep has two forward collision warning (FCW) lamps. One reports a fault, the other a setting.

  • Service forward collision warning light: a fault in the system. Often with a message ending "Unavailable Service Required".
  • FCW OFF light: collision warning, or part of it, is switched off.

What usually turns one on:

  • A setting you or a repair changed. On some models, 4WD Low switches it off.
  • Dirt, snow or fog on the windshield or grille. The message says "Limited Functionality" or asks for a wipe.
  • New glass, grille or bumper work that moved the camera or radar.
  • Out-of-date software or a sensor fault, which a diagnostic scan finds.

Calibration means re-aiming that camera or radar until it points straight down the road again. We do that nationwide.

Light staying on? Try this first

  1. 1

    Read the lamp and the words

    Note which lamp is lit and the exact message. Take a photo in case it goes away.

  2. 2

    Find the setting

    In Settings, open Safety & Driving Assistance, then Automatic Emergency Braking. Menu names vary by radio. A 2021 Compass calls it FCW Braking.

  3. 3

    Turn both features fully on

    Set forward collision warning to Warning + Active Braking. Do the same for pedestrian braking, if listed.

  4. 4

    Switch off, then restart

    Leave 4WD Low first. Turn the Jeep off and leave it parked a while, then start it again.

  5. 5

    Still lit? Get a quote

    Add the message and any glass, grille or bumper work to the quote form. Your quote names the sensor, or starts with a scan.

What a Jeep collision warning fix costs

Fixing a setting costs nothing. A camera or radar that a repair moved is priced per system below.

Calibration, per system

Diagnostic scan

Service Price
  • Same price on a mobile visit, except rows marked Shop bay only.
  • Prices are before sales tax. Whether labor is taxed depends on your state; any tax that applies is itemized on your written quote.
  • Dynamic calibration runs on the road, so it can be done as a mobile visit. Static calibration needs a level, lit, measured space, so whether your job can be done mobile depends on what your car's documented procedure calls for.
  • Rows marked Shop bay only are done in a shop bay. The bay-and-road camera price applies when your car needs both calibrations.

Jeep collision warning messages by model

2021 and 2023 Compass

Fault message:
"FCW Unavailable Service Required". A 2021 with adaptive cruise can also read "ACC/FCW" or "Cruise/FCW Unavailable Service Required".
Also worth knowing:
Switched off, it stays off after a restart, with the OFF lamp lit.

2022 Grand Cherokee (new body) and Grand Cherokee L

Fault message:
"AEB Unavailable Service Required"
Also worth knowing:
The OFF lamp stays lit unless collision warning and pedestrian braking are both fully on. 4WD Low switches it off.

2022 Wrangler

Fault message:
"ACC/FCW Unavailable Service Required" or "Cruise/FCW Unavailable Service Required"
Also worth knowing:
Cruise control drops out with it. Your setting stays as you left it.

2022 Renegade

Fault message:
"FCW Unavailable Service Required"
Also worth knowing:
4WD Low switches it off. Active braking is off while a trailer is hooked up through Mopar's towing system.

Each model links to Jeep's own owner's manual. Model not listed? Send the exact words with your VIN.

Know your Jeep's collision warning

Most Jeep collision lamps come down to a setting, a repair or a sensor knocked off its aim. Find yours below.

Collision warning has three settings:

  • Off: no warning and no automatic braking. The FCW OFF lamp lights.
  • Warning Only: a chime, but no automatic braking.
  • Warning + Active Braking: both. Factory setting on the Compass (Full On), Grand Cherokee and Renegade.

A 2021 Compass names it FCW Braking. A 2022 Wrangler lists Only Warning or Warning and Braking.

A 2022 Grand Cherokee's OFF lamp stays lit on Warning Only. Both braking features must be fully on.

Compass, Grand Cherokee and Wrangler keep the setting at restart. Off for the trail? Turn it back on.

Four automatic braking events in one drive switch active braking off. It's back at the next start.

Sources: Jeep, 2022 Grand Cherokee Owner's Manual; Jeep, 2023 Compass Owner's Manual; Jeep, 2022 Wrangler Owner's Manual.

Jeep forward collision warning questions

In Settings, open Safety & Driving Assistance, then Automatic Emergency Braking. Menu names vary by radio. Set forward collision warning to Off.

Off hides the warning but fixes nothing, and loses automatic braking. On the Compass, Grand Cherokee and Wrangler it stays off after a restart.

A fault lamp, or a "Service Required" message that's back after a restart, needs a check. Get a quote with the exact words.

Check which lamp it is. The OFF lamp means collision warning is switched off, so turn it fully on and restart the Jeep.

A fault lamp after glass or front-end work can mean the camera or radar moved. Camera calibration is $300, radar $330.

Still lit after calibration? A scan looks for the cause, such as old software or a failed sensor.

A replaced radar has to be set up for your Jeep, then calibrated. Your quote lists both.

Automatic emergency braking is unavailable. It points to a fault in the system itself. The Jeep still drives, but get it checked.

"AEB Limited Service Required" is a passing limit, like a dirty windshield. It clears when the condition passes. If it doesn't, get it checked.

After glass or front-end work, the camera or radar may need calibrating: $300 or $330. Get a quote.

No. The manuals point you to an authorized dealer, but a setting is free to fix yourself. And calibration isn't dealer-only work.

We re-aim the camera or radar nationwide. Prices per system are on the pricing page.

Still under warranty? Check with a Jeep dealer first whether the repair is covered.

If the setting or a restart clears it, nothing. Front camera calibration is $300 and front radar calibration is $330 at a service center.

Prices are per system, before sales tax where your state charges it on labor, and the full rate card is on the pricing page.

Your Jeep may need one of them, or both. A diagnostic scan, when your job needs one, is priced and itemized separately.

Check your policy. If new glass or a collision repair caused the lamp, ask the insurer if calibration can go on that claim.

Our quote prices each sensor on its own line, ready for the adjuster.

Lamp still on after the settings check? Send the VIN

Add the exact message and any glass or front-end work. Your quote is confirmed in writing before anything is scheduled.

Get a quote

Updated